- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-27-2024 10:02 PM - edited 06-27-2024 10:04 PM
Hi, I am new to ADB and started recently using this community edition. I created a cluster and it is terminating immediately when i use to connect.
What I am missing or what i need do? kindly help me.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2024 09:09 AM
Hello many thanks for the question, is this happening since compute creation? or you did create the compute, it ran, the compute was terminated and you are looking to start it again?
In community edition you need to create a compute each time you want to run an activity, you cannot reutilize the compute previously created. Please test creating a new one and let me know if it runs successfully.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2024 09:09 AM
Hello many thanks for the question, is this happening since compute creation? or you did create the compute, it ran, the compute was terminated and you are looking to start it again?
In community edition you need to create a compute each time you want to run an activity, you cannot reutilize the compute previously created. Please test creating a new one and let me know if it runs successfully.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-30-2024 09:09 PM
Hi Walter_C, thanks for your response. Your assumption is correct. Now I tried to create new Cluster whenever I start practice. Then no issues.

