- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
โ06-17-2023 09:15 PM
Hi everyone,
I was wondering if perhaps someone of you could tell me which kinds of outputs are kept in a notebook after the cluster to which it is attached is terminated... Actually, I am asking it especially because I lost some visualization that I had built from date in a table.
Thanks in advance.
- Labels:
-
Community Edition
-
Notebook
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
โ06-18-2023 05:10 AM
As long as you create an output in a notebook it will stay until you run again. If ypu want to keep a visualization try adding it to a dashboard ao you can navigate to it outside a notebook. You may want to put all code in a single cell that generates the notebook so you can click the regenerate visualization button within the dashboard from time to time. Hooe this helps.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
โ06-18-2023 04:55 AM
Hi @รscar Alberto Barbosa Bohรณrquezโ
Great to meet you, and thanks for your question!
Let's see if your peers in the community have an answer to your question. Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
โ06-18-2023 05:10 AM
As long as you create an output in a notebook it will stay until you run again. If ypu want to keep a visualization try adding it to a dashboard ao you can navigate to it outside a notebook. You may want to put all code in a single cell that generates the notebook so you can click the regenerate visualization button within the dashboard from time to time. Hooe this helps.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
โ06-18-2023 09:18 AM
Great. Thanks a lot.